Energy UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE 1
Standard Description
This power unit is built exclusively for the little lift table,Consisting of higher pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has been widely utilized while in the field of logistic products including minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled from the solenoid valve with all the pace controlled by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
General Description
This electrical power unit is built exclusively for your medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and the velocity controlled through the adjustable needle valve. Once the lift rises to a large positoin, but the electrical power supply is cut, the decreasing movement is controlled by the manual override perform.
Electrical power UNITS FOR LIFT TABLE 3
Basic Description
This electrical power unit is created solely for your substantial lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as speed controlled by a strain compensated flow handle valve.
Electrical power UNITS FOR LIFT TABLE four
Standard Description
This power unit is developed solely to the substantial lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as the pace managed by the adjustable needle valve. Once the lift rises to a higher positoin, but the energy supply is reduce, the reducing movement is controlled by the guide override function.
Distinctive Notes
1. This energy unit is of S3 duty cycle, which may only function intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean the many hydraulic elements concerned just before installation of the electrical power unit.
3. Viscosity from the oil shoud be 15~46 cst,which need to also be clean and absolutely free of impurities.N46 hydraulic oil is advised.
4. Oil changing is needed right after the original 100 operation hours,afterwards once each 3000 hours.
5. The electrical power unit shown is created to be mounted vertically.